Is Playing Records At The Wrong Speed Bad?

What is the rarest 45 record?

Blues Collector and longtime Rare Records dealer John Tefteller won a recent eBay auction which featured a previously unknown and potentially one of a kind Blues 45 rpm record produced by the Sun label back in 1953.” I think I stole it,” said Tefteller of the record when the auction ended with his winning bid of ….

What is better 33 or 45 rpm?

Vinyl records sound better if they are cut at higher speeds. Through this process, records cut at 45rpm can sound more detailed and run a lower risk of distortion, noise, and other sonic artifacts that can occur during vinyl pressing than records cut at 33rpm. …

Why do records play at 33 rpm?

The original acceptance of 33 1/3 by RCA in 1931 was a compromise between sound quality – the slower the rotation, the poorer the sounds quality – and quantity of recording time. The original microgroove could hold 23 minutes of recorded music. This was a huge increase from the 5 minutes per side of the 78.

What RPM do records play at?

Vinyl records come in three speeds: 33 1/3 rpm (often just called a “33”), 45 rpm and 78 rpm. The “rpm” is an abbreviation for “revolutions per minute” — an indication of how fast the record is meant to spin on the turntable.

What is the most common vinyl record speed?

78 RPM33, 45, and 78 RPM is the speed at which the most common commercially available vinyl records spin at represented in revolutions per minute. The records themselves are often referred to by their speed.

How many times can a record be played?

A well-cared for record can be played more than 100 times, with only minor audible sound degradation. If carefully maintained the same disc could be played many hundreds of times in its lifetime. A record played on poorly set-up equipment can be destroyed in just one spin.

What happens if you play a 45 record at 33?

The tip mass of the stylus will probably erase the highest frequencies from the record if you play it back at 45 instead of 33. The tip mass of the stylus will probably erase the highest frequencies from the record if you play it back at 45 instead of 33.

Does playing a record backwards damage it?

Playing records backwards won’t damage the vinyl, but if your deck and stylus aren’t set up for it, you’ll damage them. … Because the needle is moving much faster in the groove it’s more likely to jump and skip, potentially scratching your records. Backwards is also dangerous. Most cartridges hold the needle at an angle.

Can you play a 45 on a record player?

Unsourced material may be challenged and removed. A 45 rpm adapter (also 45 rpm record insert, 45 rpm spindle adapter, or 7 inch adapter, the common size of 45 RPM records) is a small plastic or metal insert that goes in the middle of a 45-rpm record so it can be played on the standard size spindle of a turntable.

Why do 45s have a bigger hole?

According to several websites, including Answerbag, the reason for the large hole used by 45s was simple. It was difficult for the old 78s, with their smaller holes, to find their way onto jukebox spindles. The large hole effectively eliminated that problem.

What happens if you leave a record playing?

Once you are finished with a record, make sure to always place the record back into its sleeve. Even the advanced vinyl enthusiast may forget this step from time to time, but leaving records out of their sleeves increases the risk of dirt, dust and sunrays from compromising the vinyl’s sound quality.

What speed should a record player be?

Vinyl is pressed in one of 3 speeds: 33 1/3 Rotations Per Minute (RPM), 45 RPM, and 78 RPMs. The majority of 12-inch long play (LPs) are 33 1/3 RPMs, and most 7-inch extended play (EPs) or singles are 45 RPMs. However, 10-inch discs are common at both speeds and there are exceptions (e.g. 12-inch 45 RPM discs).

Why do records play at different speeds?

The slower a record turns, the worse the audio sounds. Due to this, in order to provide the best sound possible, the record needs to turn faster (higher RPM). However, when a record turns faster the amount of information it can hold on a record is reduced thus having a shorter playback time.

How do you tell if vinyl is 33 or 45?

12″ records that are albums (>20 minutes per side) are 33, 12″ records that are singles may be 33 if they are from the US or 45 if they are from Europe. 10″ records are usually 33, but there may be 45 as well. It is printed on the label.

Can you skip songs on vinyl?

A very common question that comes up frequently is this one: “Can I skip tracks on vinyl?” The plain and simple answer to that is: Yes. You can skip tracks on vinyl records. Anyone can do it.

Can you fix a scratched record?

While there is no foolproof way to repair scratches on vinyl, you can try using wood glue to remove dust and even out the surface of your record. … If your record still skips after cleaning it a few ways, you may need to purchase a new one.

Are most vinyl 33 or 45?

Vinyl records are produced to be played at one of three speeds: 33 1/3 RPM, 45 RPM, and 78 RPM. You will almost never deal with 78 RPM records, so don’t worry about that. Most full-size 12-inch records will be 33 1/3 RPM, though some — mainly EPs and maxi-singles — will be at 45 RPM.

Why do 45 rpm records sound better?

The higher rotation speed of 45 RPM allows for a wider frequency response, and the larger available surface area allows for less compression of any signals with a wide amplitude. Bass is an example of a wide amplitude signal that sounds better on 45. Overtones and high treble are also better.