Question: Why Do Records Play At Different Speeds?

Can you play 45s on a regular record player?

Each adapter allows you to play 45 RPM singles on almost any record player.

The adapters are easy to use, simply snap it into the center of the 7″ record and place on the turntable spindle – no tools are required!.

What is better 33 or 45 rpm?

Vinyl records sound better if they are cut at higher speeds. Through this process, records cut at 45rpm can sound more detailed and run a lower risk of distortion, noise, and other sonic artifacts that can occur during vinyl pressing than records cut at 33rpm. …

Is playing records at the wrong speed bad?

Playing vinyl records at the wrong speed does not do any damage. The audio will not sound as intended, but there will be no lasting extra damage if the standard RPM speeds are used.

How many times can a record be played?

A well-cared for record can be played more than 100 times, with only minor audible sound degradation. If carefully maintained the same disc could be played many hundreds of times in its lifetime. A record played on poorly set-up equipment can be destroyed in just one spin.

What is the most common vinyl size?

The most common sizes are seven, 10, and 12 inches in diameter, but size isn’t the only way to identify what kind of vinyl record you have….Vinyl Record Formats78 RPM Records History: … 331⁄3 RPM: … 45 RPM:Jul 19, 2018

Is it bad to leave the needle on a record?

Leaving a stylus on a stationary record is perfectly fine. No damage has been done. Leaving it in the runout groove overnight, on a spinning turntable, will also not do any harm, but it will take a couple of hours off of the stylus life.

Does playing a record damage it?

As for wear-induced noise, most of that comes from playing records with a worn-out or damaged stylus (aka needle) that’s literally gouging the grooves with each play. Any decent cartridge will play records without damaging the groove. … A force setting that’s too high or too low can accelerate record wear and noise.

Can you fix a scratched record?

While there is no foolproof way to repair scratches on vinyl, you can try using wood glue to remove dust and even out the surface of your record. … If your record still skips after cleaning it a few ways, you may need to purchase a new one.

Why do 45s have big holes?

According to several websites, including Answerbag, the reason for the large hole used by 45s was simple. It was difficult for the old 78s, with their smaller holes, to find their way onto jukebox spindles. The large hole effectively eliminated that problem.

How do I know if my record is 33 45 or 78?

You can usually tell if a record is a 33 RPM or 45 RPM by looking at the label. Also, if it’s vinyl, it’s not a 78.

How do you know what speed to play vinyl?

Vinyl records are produced to be played at one of three speeds: 33 1/3 RPM, 45 RPM, and 78 RPM. You will almost never deal with 78 RPM records, so don’t worry about that. Most full-size 12-inch records will be 33 1/3 RPM, though some — mainly EPs and maxi-singles — will be at 45 RPM.

What happens if you leave a record playing?

Once you are finished with a record, make sure to always place the record back into its sleeve. Even the advanced vinyl enthusiast may forget this step from time to time, but leaving records out of their sleeves increases the risk of dirt, dust and sunrays from compromising the vinyl’s sound quality.

Can you skip tracks on vinyl?

A very common question that comes up frequently is this one: “Can I skip tracks on vinyl?” The plain and simple answer to that is: Yes. You can skip tracks on vinyl records. Anyone can do it.

What happens if you play a 45 record at 33?

The tip mass of the stylus will probably erase the highest frequencies from the record if you play it back at 45 instead of 33. The tip mass of the stylus will probably erase the highest frequencies from the record if you play it back at 45 instead of 33.

Can a record player play any size vinyl?

All record players do not play every single size of vinyl record. All record players will play the two most common sizes of vinyl record, those being 12-inch and 7-inch, but it is far less likely they will be able to play a 10-inch record.

Why do vinyls sound better?

To be sure, the sound of vinyl carries additional warmth when recorded through analog rather than digital technology. Richness refers to the diversity of auditory aspects heard in vinyl records. Because of record grooves, the sound of vinyl is more open, allowing a greater quantity of features to be heard.

What diameter is a 33 1 3 record?

10-inchThe LP (from “long playing” or “long play”) is an analog sound storage medium, a phonograph record format characterized by: a speed of ​33 1⁄3 rpm; a 12- or 10-inch (30- or 25-cm) diameter; use of the “microgroove” groove specification; and a vinyl composition disk.

What speed do most records play at?

Vinyl records come in three speeds: 33 1/3 rpm (often just called a “33”), 45 rpm and 78 rpm.

Why do records play at 33 rpm?

The original acceptance of 33 1/3 by RCA in 1931 was a compromise between sound quality – the slower the rotation, the poorer the sounds quality – and quantity of recording time. The original microgroove could hold 23 minutes of recorded music. This was a huge increase from the 5 minutes per side of the 78.

Does playing a record backwards damage it?

Playing records backwards won’t damage the vinyl, but if your deck and stylus aren’t set up for it, you’ll damage them. … Because the needle is moving much faster in the groove it’s more likely to jump and skip, potentially scratching your records. Backwards is also dangerous. Most cartridges hold the needle at an angle.

Is it bad to hang records on the wall?

Feature walls can make a huge statement in any space, but they can also be a big commitment. … Yes, even 135 records can be mounted on the ceiling or wall without a single nail, screw, or dab of glue!